WinVICE r45197

WinVICE r45197 is released. WinVICE is a program that executes programs intended for the old 8-bit computers. The current version emulates the C64, the C128, the VIC20, all the PET models (except the SuperPET 9000, which is out of line anyway), the PLUS4 and the CBM-II (aka C610).

WinVICE Changelog:
r45197 | gpz | 2024-06-21 22:00:17 +0000 (Fri, 21 Jun 2024) | 1 line
fix mapping for keypads attached to joyports
————————————————————————
r45196 | gpz | 2024-06-16 21:49:27 +0000 (Sun, 16 Jun 2024) | 1 line
remove support for right and middle button with Amiga and AtariST mice – These connect POT lines with GND when pressed, and are open if not, which the C64 can not detect (since there is no pullup resistor)
————————————————————————
r45195 | gpz | 2024-06-16 21:09:47 +0000 (Sun, 16 Jun 2024) | 1 line
allow 8 controller ports for plus4, should fix bug #2041
————————————————————————
r45194 | gpz | 2024-06-16 20:32:50 +0000 (Sun, 16 Jun 2024) | 1 line
fix device struct, this keypad does NOT use the pot lines
————————————————————————
r45192 | gpz | 2024-06-16 18:54:40 +0000 (Sun, 16 Jun 2024) | 1 line
make comments match the code, part 2 🙂
————————————————————————

Download: GTK3VICE r45197
Source: Here